Lotus 2-Eleven C1324 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Lotus 2-Eleven C1324 Possible Cause

Common causes of Lotus 2-Eleven C1324 include a faulty electronic pressure control solenoid, hydraulic blockages inside the internal transmission fluid passages, mechanical internal transmission failures, low transmission fluid, dirty or contaminated transmission fluid, a faulty PCM or transmission control module.

Common Symptoms For Lotus 2-Eleven C1324

  1. Repair or replace circuitry, connectors, and/or components as required
  2. As the input shaft is turned (by the engine) the electro magnetic input/turbine speed sensor uses the spaces between the splines to provide voltage signal interruptions in the circuit
  3. CAN is the abbreviation for "controller area network." The CAN represents a communication bus that allows multiple microcontrollers to communicate with one another without the need for a host computer
  4. Several tools will be instrumental in successfully diagnosing this code

Similar Problems

Fuel And Air Metering (Injector Circuit Malfunctions Only)
Exhaust Gas Recirculation System Valve 1
Transmission Control Module Reprogrammable Memory

Lotus 2-Eleven C1324 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Lotus 2-Eleven C1324 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Lotus 2-Eleven C1324 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.